Hospira Lifecare PCA with Mednet
Rx only. Sold to healthcare facilities, licensed practitioners and equipment service providers; not sold to patients for home use (Terms §8).
- Dimensions: 13” H x 8” W x 6” D (excluding pole clamp and power cord storage)
- Weight: 10 lbs (with battery)
- Delivery Rate Modes:
- Accuracy: ± 5%
- PCA Only: Approximately 1 mL in 35 seconds
- Continuous Only: Variable from 0.1x concentration to 20x concentration (mg/hr or mcg/hr)
- PCA Continuous: Variable from 0.1x concentration to 20x concentration (mg/hr or mcg/hr) PCA dose (mg)
- Lockout Interval Range: 5 to 120 minutes, in one minute increments
- Occlusion Alarms and Limits:
-
- Occlusion Alarm Pressure: 15 ± 5 psi
- Maximum Infusion Pressure: 45 psig
- Maximum Over-infusion: Under single fault conditions = 25%
- Occlusion Bolus Volume: 2 mL for fully primed set (max)
-
- Power Requirements: 100-240 VAC; 50-60 Hz; 50 W
- Power Cord: Hospital-grade AC cord; 10 feet; with transparent plug and retainer (Fuses – 0.5 A, 250 V, Slo-Blo)
- Battery Operation: A fully charged new battery provides approximately 3 hours of operation from the start of delivery at 5 mL/hr, to dead battery
- Recharge Time: After a low battery alarm, the battery will recharge to 80% of full capacity within 16 hours
Trademark Notice: ICU Medical, Hospira, and all other brand names, model names, and part numbers shown are trademarks of their respective owners and are used on this page only to identify the original manufacturer’s equipment offered here, consistent with nominative fair use. This listing is offered by IPR Medical, an ISO 9001:2015-certified independent service organization, and is not sponsored by, affiliated with, or endorsed by ICU Medical or Hospira.
- Drug Recognition:
- Built-in bar code reader automatically identifies drug name and drug concentration in the vial of all prefilled Hospira vials. The bar code reader can recognize custom-filled vials of pharmacy-generated barcodes when Hospira MedNet software is enabled.
- Programming:
- Designed to help reduce medication errors, enhance utility and increase efficiency
- Advanced software, soft-function keys and numeric keypad with decimal point & icons for easy use
- Prompting alphanumeric display
- Review screen confirms data input before infusion begins
- Auto-programming available
- Biomedical:
- RJ-45 Ethernet connector
- Software is field upgradeable
- Diagnostic setup options
- Alarm history
- Stored speed protocol function for Hospira prefilled vials and custom (sterile empty) vials
- Nurse call relay connector
- Infusion history
- Various Modes of Delivery: PCA only, Continuous, and PCA Continuous
- Wireless antenna
- Microprocessor control
- LCD and LED display
- Back panel illumination
- Security features
- 8 V battery for emergency backup and temporary portable operation (approximately 3 hours)
- Casing: High-impact plastic
- Self-Discharge: A fully charged battery will retain 20% of the initial charge for 6 months when the infusion pump is not connected to AC power or is not operating
Alarms:
- Barcode not read
- Check settings
- Occlusion
- Check syringe, vial, injector
- Empty syringe
- Door open
- Infuser paused
- Invalid Barcode – Replace vial
- Low battery
- Dead battery
- Pendant fault – O
Repair service: IPR Medical also repairs ICU Medical and Hospira pumps in house, with a free shipping label, a free evaluation and a 90-day repair warranty. See ICU Medical and Hospira pump repair.
Trademark Notice: ICU Medical, Hospira, and all other brand names, model names, and part numbers shown are trademarks of their respective owners and are used on this page only to identify the original manufacturer’s equipment offered here, consistent with nominative fair use. This listing is offered by IPR Medical, an ISO 9001:2015-certified independent service organization, and is not sponsored by, affiliated with, or endorsed by ICU Medical or Hospira.
| Weight | 10 lbs |
|---|---|
| Dimensions | 6 × 8 × 13 in |
Related Products
Reviews
There are no reviews yet.